The best solution is to install the valve body with the plaster ground 3/8 back from the finished wall. This would provide a 1/8 space between the back of the handle and the escutcheon, perfectly acceptable.

How do you measure shower valve depth?

0:404:14PLACEMENT OF SHOWER VALVE subscriber requestYouTubeStart of suggested clipEnd of suggested clipThis is the very lowest point where your finished wall could possibly be. This is the very furthestMoreThis is the very lowest point where your finished wall could possibly be. This is the very furthest point where your finished wall could possibly be.

How do you install a rough in shower valve?

2:344:23Moen Shower Valve Installation Tips - YouTubeYouTubeStart of suggested clipEnd of suggested clipPut this in place. Make. Sure everything was plumb. And we screwed the drop elbow. To our tube byMorePut this in place. Make. Sure everything was plumb. And we screwed the drop elbow. To our tube by material. Then we cut holes in our studs. Going down into the first floor.

How much room do you need for a shower valve?

The shower valve should be 12 inches apart. The next stage of the project will be aided by a small mark at the center of the plates, in line with where you expect the shower valve and faucet to be. On either side of the midpoint, mark 6 inches.

How do you adjust a shower faucet that sticks out?

6:177:42How To Adjust A Shower Faucet That Sticks Out - YouTubeYouTubeStart of suggested clipEnd of suggested clipInstead I employed a different method. Where I smeared it onto the shims. Before I wedged on thereMoreInstead I employed a different method. Where I smeared it onto the shims. Before I wedged on there but I also put it on a piece of wood and pasted it on there as well.

Are shower rough in valves universal?

Yes! Shower rough in valves without stops are by far the most common. They work absolutely as well in every way.

How do I adjust my shower?

0:193:27How to adjust your shower water temperature colder or hotterYouTube

What height should a shower mixer be?

between 36 and 48 inches There is no set height for the water controls. Since youll want to mount the controls lower to accommodate tub users, take into account whether the controls work the tub and shower. It is common for shower-only controls to be between 36 and 48 inches from the floor.

Are rough in valves interchangeable?

First, you absolutely CANNOT mix manufacturers on trim and rough-in valves. In fact, even within one manufacturer, they have many valves and the trims are not interchangeable. Shower sets are not always sold as separate trim and rough.

Does water splash out of a walk-in shower?

A doorless (i.e., walk-in) shower requires sufficient space and design to contain the water flow and splash. If the shower is too small, the floor cannot slope for adequate drainage and water will seep out through the opening. A larger shower simplifies the sloping process.

How do you adjust a mixing valve?

To adjust the temperature supply remove the plastic cap on top of the valve and adjust with a close fitting spanner. To increase the temperature turn anti-clockwise To decrease the temperature turn clockwise To set the valve to a maximum recommended mixed water temperature, see table below.